No heading on networked displays
Question
I have no heading on my networked displays. The heading is okay on the display with heading directly connected to the display. Why does it only show on the one display?
Solution
Heading must be input into the radar display only. If it is AD10 Furuno format it will pass through the network to the other displays.
If it is NMEA format it can pass through to the other displays as well. To set this up properly the [OUTPUT THROUGH NETWORK] port [HDT], or [HDG] NMEA sentence must be selected [ON]in the radar display. The NMEA heading must connect to the heading port of the radar display on pin 1(white wire) and pin 2(black wire) only. Please check your installation manual for further details.
NOTE: Do not connect NMEA heading to pins 3 and 4 of the heading connector. This will cause a constant heading error of 000.0.

Radars
Fish Finders & Transducers
GPS & Chart Plotters
Autopilots
Navigation
Sonars
Commercial